Futek IHH500 Series Manuel d'utilisateur télécharger pdf (Page 10)

TEDS is a small chip that can store a sensor’s calibration information. The IHH500 can read it upon power up, or by loading it

through the menu, and setup a proﬁle with the stored information.

TEDS MENU

1. Menu

2. TEDS Data

3. TEDS Device — Will show information about TEDS chip.

4. TEDS Pages — Shows programmed information stored

in chip.

5. Load Data — Will load TEDS information into IHH500.

6. Auto Detection — Sets the IHH500 to automatically

load TEDS information upon power on.

CHANNEL SELECT (CALIBRATION PROFILE SELECT)

1. Menu

2. System Setting

3. Channel Select

4. Use the left and right arrow key to choose the desired

channel.

5. Enter to load Channel or Proﬁle.

TEDS and Channel Select

TEDS calibration information can be

viewed upon loading TEDS, either during

a power on or while selecting Load Data

under the TEDS menu.

The TEDS chip should be placed within

5ft. of the IHH500 sensor connection

to maintain proper power. Typically the

TEDS chip is placed in the sensor binder

connector.

An auto-calibration may be performed

when loading TEDS information, or a

new channel or proﬁle.

TIPS FOR USING TEDS AND CHANNEL SELECT

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Futek IHH500 Series Manuel d'utilisateur Page 10