Futek IHH500 Series Manuel d'utilisateur télécharger pdf (Page 9)

9

The decimal point can be moved by

selecting it ﬁrst and turning it into a

number, and then selecting another

digit to change it into a decimal point.

Sensitivity (+) must be entered. If only

one direction is selected, then sensitivity

(+) will be applied to both directions of

output or negative direction output.

Sensitivity is the sensor’s output level,

such as mV/V output, and is found on the

calibration certiﬁcate.

Pressing back without saving will prompt

to exit without saving. Enter can be used

for Yes, and Back for No.

IHH500 Elite supports Encoders through

Pulse proﬁles.

Current proﬁles cannot be set up

manually and must be set up using the

Live Calibration feature in the proﬁle

setup.

Full bridge sensor type is for mV/V

output sensors.

TIPS FOR SETTING UP A PROFILE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Commentaires sur ces manuels

Pas de commentaire