Futek VCal Sensor Verification Manuel d'utilisateur télécharger pdf (Page 30)

Futek Advanced Sensor Technology – Futek VCal™Documentation Rev. 1.8.0 07/26/05

©Futek Advanced Sensor Technology 2005

The rest of the Calibration / Verification interface is (like the Reference Sensor interface) divided into two main sections; the Information Tabs

section, and the Test Grid section . . .

Information Tabs Section - Under the Information Tabs section there are four tabs; Info, Initial, Setup, and Test . . .

First is the Info Tab, this is where you will enter the descriptive Sensor Information for your test. Please note that Text Box Titles which are

displayed in Blue are required information if you wish to perform a calibration or verification.

Manufacturer - This is where you will enter the name of the Manufacturer of

the load cell you are calibrating or verifying. Again (as in the Reference Sensor

interface) the icon with the down arrow just to the right of the text box,

will bring up a pull-down menu of the Manufacturer names you have saved in

the Management Tools section, and the icon with the three periods will take

you to the section of Management Tools where you save Manufacturer Info.

Model - This is where you will enter the Model Number or Model Name of the

sensor you are calibrating.

Sensor Type - This is where you will enter the Type of sensor you are

calibrating. Again, there are the down arrow and three period icons for

entering saved Sensor Types and for going directly to the Sensor Type section

of Management Tools. (pg. 37)

Serial Number - This is where you will enter the Serial or ID Number of the

sensor you are calibrating.

PO - This is where you will enter the Purchase Order number if applicable to your situation.

Customer - This is where you will enter the name of the Customer for whom you are performing the calibration. Once again there are icons

available for accessing saved customers and for going to Management Tools. ( pg. 37)

Channel / Bridge - This is where you will enter which Bridge ( on multi-channel sensors) you are calibrating (default is channel 1).

Load Direction - This is where you will enter which Direction you wish to apply your Load in (Compression, Tension, CW, CCW, etc.). There are again

the icons available for accessing your saved load directions, and for going to Load Direction in the Management Tools section.(pg. 38).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 64 65

Pas de commentaire

Futek VCal Sensor Verification Manuel d'utilisateur Page 30